...bracket. Remove the powertrain control module (PCM) electrical connector bolt. Pull the connector from the PCM and position aside. Remove the two PCM bolts. Remove the PCM relay. Remove the three ...
...panel system consists of the following components: RH circuit breaker Timer module Power window relay Roof sliding panel switch (15B691) Roof glass panel (50054) Sliding roof panel motor (15790) ...
...turn signal relay located in a 1995 mercury villager? http://groups.yahoo.com/group/villagerquest/ behind dirver side kick panel. remove bracket with 2 10mm bolts on it. has 3 relays on it. Lucas ...
...relay pane and start the engine. Let it idle until it stalls, and then crank the engine for about 5 seconds to make sure the pressure was released. Turn the ignition off. 2Disconnect the negative ...
relay is above and behind the fuse panel on the dash. 2 relays and turn signal flasher in same area. Turn signal light on to locate flasher. 2 bolts hold bracket with relays & flasher. gerry http:
Question about 2002 Villager
...bracket securing it on the back side. An inspection mirror comes in handy to locate these types of fasteners. You may be able to locate it by running your hand along the back side of the plenum 93 ...
Usually answered in minutes!
478 Questions
379 Questions
326 Questions
276 Questions
247 Questions