Questions & Answers for: reinstall tray Cars & Trucks

...another two bolts. Then you will see the battery tray. Install the battery and holddowns, and connect the cables (side connectors). Replace the windshield washer reservoir and reinstall the

tray, remove the cig. lighter and bezel. Then remove the two screws holding the cig. lighter compartment and pull it from the lower left coner to remove it. Now you'll see fuses and relays, look for a

...tray and you need to put the car in gear to open it up, ditto to reinstall. Be patient reinstalling it can be a bit tricky. If the fuse has blown it may be the cigarette lighter needs to be replaced, ...

...tray/cigarette lighter pulls forward, allowing access to the rear of the lighter socket. Remove the electrical connection and then turn the retainer counter-clockwise. The socket removes from the ...

...the battery tray, you simply lift up on the bolt and it will pull the plastic block up with it.When reinstalling the battery, make sure you slide the battery base under the lip in the battery tray ...

...reinstall a battery in a 2001 chevy lumina? there is a wedge of some type i don't know where it goes 1. Place the battery in the car so that the red cable is closest to the positive (+) post ...

How do you remove the glove box on a 1999 Olds Alero? Remove 6 screws tray slides out. make sure latch works upon reinstall

...the lamp unit and replace it with the new one. reinstall four screws. Plug wire into the new lamp. Then reinstall the plastic splash tray under the bumper and the wire grill around the light.

...reinstall sit the battery into the back edge of the tray like sliding in a baking tray into a low oven. this will allow the battery housing to fit under the back lip of the battery tray. Slide the ...

...reinstall battery cables and battery tray I have just finished replacing my clutch and I'm at the point where all I have to is reconnect battery cables and battery tray but the person who took the ...