Questions & Answers for: refrigerator cap tube replacement

Question about Refrigerators

5 Answers

...cap tube must be cleared for the unit to cool properly and to allow enough cool refrigerant to return to the compressor to keep it cool. I have heard from a fellow technician recently who tells me ...

Ad

Question about Elite 22.4 cu. ft. Bottom Freezer Refrigerator with Adjusta Cube Ice Maker

1 Answer

...refrigerator is located at the front base of the unit, in the grille, below the freezer door. There, you will see a round cap. Turn the cap counter-clockwise, until the handle is vertical.Then, pull ...

Ad

Question about T-49 Side by Side Refrigerator Commercial

2 Answers

...cap tube you will have to do the following. Purchase cap tube replacement from supplier. Recover your refrigerant. Use your torch to remove the cap tube. Weld in new cap tube (make sure you have it ...

Question about T-49 Side by Side Refrigerator Commercial

1 Answer

...REFRIGERATOR ? First , install a clamp on access valve on the compressor assecc tube . This is usually the 3/8 " , short tube , mounted on the compressor . Next , connect a refrigerant reclaimer with ...

Question about T-49 Side by Side Refrigerator Commercial

2 Answers

...refrigerator low side with liquid , only gas . The high side can be charged with liquid . ) A cap tube separation , is when the pressurized ( causes heat ) cap tube , becomes separated from the low ...

Question about JCD2389G Side by Side Refrigerator

1 Answer

...cap located on the back of the *** behind the ice maker. What is thi part called and can I replace it? Sounds like the fill tube to the icemaker has frozen shut. The fill tube will need to be thawed ...

Question about JCD2389G Side by Side Refrigerator

2 Answers

cap tube...the refrigerant is not getting through the expansion device quickly enough...causing the unit to pull a vacuum... replace the expansion tube which can be darn near impossible on many units.

Question about NDR 1062 Refrigerator

1 Answer

...Tell him to remove the strainer, remove cap tube, blow out system with nitrogen, install new strainer/ filter drier, install new cap tube and charge, you should be as good as new. Hope this

Question about NDR 1062 Refrigerator

1 Answer

...cap tube. You can then mic the butt end or cross reference to chart giving size of numbered drill bits. The length is also very important when sizing, cap tubes must be as close to exact length as ...

...your problem. It has to be a certain length to operate correctly. That's why there's a coil of tubing. It is not too long. You'll have to replace the entire cap tube for that model of

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Are you a Refrigerators Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...