Questions & Answers for: Ford referencing

Jeep won't start My jeep wont start how would I know if it is just the starter relay locate your relay. swap it with an identical relay in your power distribution box and see if it starts this is the ...

could anyone tell me how to find the "shift solenoid" for a ford explorer? geode07 : Not knowing which shift solenoid you are seeking, I will give you both. The first has to do with the internals of ...

ford couger lower front susp/arm does a ford mondeo lower front susp/arm fit a couger? I went to my local ford dealers and cross referenced part numbers for the couger and mondeo of the same ...

I ran tthe DTC received a 412 and 538 both referencing the Idle speed issue. I am trying to trobleshoot so do I start with the Throttle Position Senssor Or IAC ???? IAC. Common issue on Ford vehicles.

what mass airflows from ford cars fit a 1998 explorer? Cross referencing the part number - it looks like only the following with work properly: 1998 Mountaineer, 1997 - 2000 Ranger, 1997 Explorer

How much amuont of airconditioner fluid is required on Ford Windstar 2001 The system is serviced by referencing the compressor discharge pressure vs the suction pressure and the temperature of the air

I'm sure there are others that also sell te same part. This is where I purchased mine so I'm simply referencing at least one place you can source the part

2002 mustang door lock problem,driver side all new switches if switches are new, I would checck the wiring in the door jamb between the door and the chasiss. wiring most likely in a rubber sheeting. ...

Won't start Replaced the starter, starter coil, spark plugs, fuel regulator...the battery is good. We attempted a compression test, but when we tried to start her again, it just kept turning over ...

trying to find out which is coil h and g on ford f.4 3 valve Part of your post is unclear but the engine is referenced to by bank 1 and bank 2 aND bank 1 is the passenger side /bank 2 the drivers side