...fresh fuel.if bike still wont start ,take off carburator & intake boot & pullout intake reed assembly,checking for broken or frayed reed petals.replace if worn or broke.reassemble.try to ...
kx 125 reed valves I need to know how you know if the reed valve is bad on kx 125 looks to be not broken or chipped or bent open in any way... The reed valve assembly should hold solvent withot ...
...wont start unless u pull start it. but it dies unless u keep the revs up about half throttle. the reed valve is good, air cleaner good, new spark plug, i pulled the exhaust valve cap off and black ...
...80 HAS 65 PSI COMPRESSION AFTER TOP END REBUILD VERY HARD STARTING You may have a problem with your reeds.If you have done a rebuild because something internally has destroyed itself then the chances ...
...and then blow out all passages with compressed air and reassemble. You should also pull off your reed cage and check to make sure that your reeds aren't cracked or broke. If your bike was runninng ...
...under load, the bike misfires pretty bad. I cleaned the carb, installed new plug, and the reed valves look ok. Any idea?? muffler bearings ...
i bought a 03 kx125 and when you take off 1st 2nd gear it runs like the plug is filed the guy that sold it to me said he trimmed the reeds to get a better bottom end take off but to me it seems like ...
my kx 2005 was runnin great them started bogging randomly changed reeds top end and cleaned carb... Well - not knowing the condition of the bike it could be a lot of things. I would start with a fresh
can i put a bigger reed valve in my kx 125 No u can't.
Question about 2003 KX 125
2003 KX125 glycol seeping out of vent line underneath reed valve block. Can anyone explain how this can happen? 2003 KX125 glycol seeping out of vent line underneath reed valve block. I replaced the ...
Usually answered in minutes!
239 Questions
29 Questions
21 Questions
7 Questions