my cr 250 backfires and breaks reed petals,is this an ignition failure? Look around the exhaust where it comes out of the cylinder, if the are any cracks or leaks this will cause your problem.
...replaced, new plug with good spark, fuel seems to flood back into carb rather than getting through reeds. Any ideas what could be the cause. Cheers Colin Sounds like you have very little
...honed cylinder. i have spark compression and fuel but wont start up 1979 cr125r elsinore check the reed valves, and the crankshaft seals for
...be dozens of causes. just a thought but you may have a crank seal on it's way out, or a bad reed valve seat your air/fuel screw all the way in,just until it seat DO NOT OVER TIGHTEN, then
A honda acord key is stuck in the tumbler of the A honda acord key is stuck in the tumbler a the 2000 honda okyssey it will move but wont come out. Strip the ignition switch down. Hope I helped Dr ...
hey i have a 2003 Honda cr125r 2 stroke. and i was riding it around today and after about 4-5 minutes it would just die on me no matter what speed i was going. and it would start up just fine but keep
...and ring in. Motor will not start. gas is not getting from carb to motor. Somebody told me to check reed valves. somebody else told me that the low end seals are bad. help What Honda do you have, ...
...it and the power band just stop working the bike stil runs but ther is now power Sounds like your reed valve isn't working, You'll have to remove it to see why it isn't
hi. i have a cbr 400, nc23 (1989) would like to know how much oil do you put in it?? do you take the oil reeding on or off the stand?? off the stand with the bike held verticle, the volumne is often ...
...if can let me no wot u think it might be many thanks yes it did iv fixed it now tho it was the reed had a bit missing from it so go new reeds and it runs ok but it redline a 8000 could u help me ...
Usually answered in minutes!
188 Questions
186 Questions
195 Questions
148 Questions
151 Questions
