Questions & Answers for: Mitsubishi WD red screen

...SCREEN WITH STATIC, AND RED LAMP LIGHT ON AFTER REPLACEMENT I had a blue screen with static in middle of screen, message at bottom said component cables were invalid?? I went and replaced lamp twice, ...

...red lines on my screen Screen/picture has pink lines I will assume from you description that this is a rear projection crt(picture tube) tv. if this is true I have good news/bad news. faint red ...

...red and no screen at all. I thought the lamp went out so I changed it. Now the new lamp stays light around 5 seconds turns off and tv remains power up state for 1 minute then the red lamp light turns ...

...screen wouldn't turn on and the replace bulb light was red. I replaced the bulb and now when I power my tv on I hear a static sound but the screen remains black and never comes on. The tv remains ...

...happens. The green light blinks for a minute then the yellow light just a red screen! U replaced the light engine blast?If replaced that not work.Than ur backlight video board is dead,must

screen timer flahing green then red light for bulb status, replaced bulb black screen green flashing timer for two minutes then solid red light for bulb you may be on the incorrect input channel. look

tv looks like 3d red color on screen tv looks like 3d red color all on screen cant ajust Sounds like the convergence circuit failed. Get an estimate from a repair shop. Not for DIY'ers.

...screen comes on then shut down rightaway.red light blinking. Here is a suggestion that has worked for several ...

...screen and red light. Then I replaced the bulb. Bulb did not help. Green light still goes to red. I hear clicking. I hit the reset button on the front of TV and held it for about 15 seconds. I also ...

...red light still remains. What else could be wrong? Also, the sound comes on, just not the screen. There are some adjustments should be done after the DLP chip replacement. If you wish to get some ...