Questions & Answers for: Mitsubishi red screen

screen turns red then shuts off I have this tv and it goes fine for random amounts of time and then the screen has a few red arcs on the screen and then it gets gradually more red and then all red and

...screen and found the red to be out of adjustment. It is bowed so much on the right side of the screen it cannot be compensated. Replace STK393-570 convergence IC. located on center PCB.re-check ...

extended warranty.. Always try your extended warranty!.....Probable cause = bad red tube. One adjustment may help---turn down red screen control, located behind technician access panel in front of set

...SCREEN WITH STATIC, AND RED LAMP LIGHT ON AFTER REPLACEMENT I had a blue screen with static in middle of screen, message at bottom said component cables were invalid?? I went and replaced lamp twice, ...

...red lines on my screen Screen/picture has pink lines I will assume from you description that this is a rear projection crt(picture tube) tv. if this is true I have good news/bad news. faint red ...

...red convergence screen. Also on the advanced convergence adjustment screen the horizontal lines are straight but the vertical lines are "snaked". The cross hairs will not adjust for red convergence ...

...screen and red and blue straight lines across the bottom plus the letters on the bottom will be doubled one blue and the other in red. My son took the back of the tv off just to look and the red bulb ...

red screen control is turned up too high. These sets have a small square block with RED,Green, Blue screen controls(same place also has red, green, blue Focus controls) if you remove the speaker grill

red, blyue, and green lines at top of screen, red, blue, and green lines at top of screen, screen getting darker think your lights need replacing

red screen screen is normal then all of the sudden will only show reds and blues. wont revert until tv is turned off for a period of time if the reds and blues look 3d etc it is a convergence problem.