Question about 51F500 51" Rear Projection HDTV-Ready Television
...Red power light will turn on but the projection portion will not come on. lighting can effect anything and everything, call insurance and get replacement value for set. replace middle power supply ...
Question about 51F500 51" Rear Projection HDTV-Ready Television
51f500 red tint with subtle white diagonal lines I have a red tint with very light white lines running diagonaly Thats usually a isgn of a weak resistor on the red crt PC board or the red CRT getting ...
Red want focus I can't use the magic focus to focus the red it will not line up" The fault can be on the convergence board, or in the HV multiplier. Jerry G. red will not line up at all did auto focus
Question about 51F500 51" Rear Projection HDTV-Ready Television
51F500, the picture has a red shade to the right, was able to align the center part of the screen, however not the far right & left sides by using manual adjustment, it will not respond to the control
Question about 51F500 51" Rear Projection HDTV-Ready Television
...51F500 Ours is only 5 years old and we can not get the red bars from appearing and screwing up the picture??????? It is not our provider, our other TV is fine. 5-10YEARS. THAT TV SOLD FRO 999.00 AT ...
Question about 51F500 51" Rear Projection HDTV-Ready Television
I have a red wave near the top of my hitachi rear Cusing a double image on the red in the red wave Ur convergence are dead.U know how to solders?U must replaced 2 STK convergence,and some or all it ...
Question about 51F500 51" Rear Projection HDTV-Ready Television
Hitachi 51F500 Rear Projection TV. has a red ghost on it . how do i fix this? the only way to fix this problem is by replasing the convergence ic
Question about 51F500 51" Rear Projection HDTV-Ready Television
red gun goes off and loose red color. Once and a while it will come back on. suspect a cold solder joint Quite possibly but it could be intermittant heaters in the red tube. Check when faulty!
Question about 51F500 51" Rear Projection HDTV-Ready Television
Too much red color..will not adjust Your convergence may have failed and need to be repaired. Once quick test is to goto your convergence menu and see if you can adjust red and blue. If not its has ...
Question about 51F500 51" Rear Projection HDTV-Ready Television
red bulb is out and flickers on and off COUNT THE TIMES AND SEQUENCE..OF RED FLICKERS.CONTACT TECH SUPPORT
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions