...or just drop in tone. I can't figure out if it's the record player or the needle. The turntable is the problem, possible causes motor, flat belt is stretched or direct drive issue, needs
Question about T.50 Turntable
...record player & the turntable turns slow. Takes about an hour to warm up to the right speed. Can anyone help me? The RCA 45 ey2 record player I have was totally rebuilt about 6 years ago. Obver ...
...record is very slow but speeds up after several plays. However, humming is still there! Any ideas, Please. Could do with a service. Check the turntable motor and drive plus check the cartridge and ...
Question about Pacconi Turntable
...record player runs slightly too slow. How can I fix this?? I have looked online and found that replacing the motor and belt don't help. It is running just slightly too slow. I opened up the bottom of ...
motor with a protection circuit which when becomes too warm will slow down to a stop. When the lubrication in the capstan bearings have dried out, quite common with all and now old decks, the friction
Question about Pacconi Turntable
slow ITRR -501 wood music center by Innovative Technology music center has slow turn table I replaced needle and belt but it continues to be slow. The motor may be weak or there could be a dry bearing
Question about Pacconi Turntable
Pioneer model RMX-962 the machine plays fine for about 5 minutes then the motor slows and then stops. Is this a motor issue or capacitor issue Measure the voltage going into the motor when its working
Question about Pacconi Turntable
player Drive motor (not controller motor) slowly, over time, started having trouble starting the disk and keeping it in rotation. I presume it was a bearing or bushing in the Drive motor. Is there any
Question about Pacconi Turntable
...record it slows down. I have adjusted the obvious things - counterweight, speed selector, pitch but to no avail. I have checked the belt. Thanks Check the motor bearings run freely or return it for a ...
Question about Pacconi Turntable
...RECORD, NOT SURE WHY? I THINK THE CHANGER MOTOR NEEDS TO BE OVERHAULED? I READ THAT THE MOTOR IS HARD TO PUT BaCK IN POSITION CAN YOU ADVISE?? Please don't type in all CAPS, it is considered SHOUTING ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions