...ground my receiver? Use the black wire in the wiring harness, and connect it to the black wire in the car's harness. This grounds the receiver. If you have a chassis ground (a braided cable) for the ...
...higher decible. I dont have the receiver grounded only because I'm not sure what to ground it to, could this be the problem? yes ground the turn tables usally have ground wire u tie on to bolt on ...
Question about 3300 240-Channels Base CB Radio
correct wiring for a ASTATIC TEARDROP MIKE to a RANGER RCI 2950DX here is the info you asked for the following is the correct wiring. Mic Wiring Info Stock Mic Wiring 1. Ground Shield 2. Audio Yellow ...
Question about 5.1-Ch. Surround Sound Home Theater Speaker System
...ground loop hum will most likely still be produced even in mute. If you get a hum when nothing is connected to the receiver, try looking into getting a better grounded outlet, even maybe to a ...
...in between. Disconnect the cable at the receiver and measure for ac voltage between the ground (shield) and ground on the receiver. If there is none, try just connecting the cable to the
...ground wire connection on the receiver. If this doesn't work, looking on the back there should be a grounding point, Unplug your receiver.. Split a wire and attach one of the splits to the ...
...ground wire connection on the receiver. If this doesn't work, looking on the back there should be a grounding point, Unplug your receiver.. Split a wire and attach one of the splits to the ...
...Receiver. the issue is a ground Fault the protection mode for over current in some of Yamaha's and HK receivers are the Two main Relay's if the Ground inside the amp is lose or is causing a ...
...ground post on the receiver or to the RCA jack/plug's outer ring. If the hum/buzz goes away, you're good to go and can connect the wire permanently. If not, try the ground cables individually and use ...
how do i ground it Do i run a ground wire from the receiver to a piece of mental to ground it or what If your home has copper water pipes, then run a wire to the closest pipe and clamp it right to it.
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions