anyone know what "7_U" might stand for or mean and what I can do to get my remote to respond again? Thanks. Did you try unplugging the deck? Its like a cold reboot. unplug the deck. It's a cold reboot
...reboot).Here are the steps.. The following will set your recorder to the Factory defaults. (Will not format HD on DMRE80). With power off (stand-by mode/CLOCK DISPLAY SHOWING): 1)Press and hold [skip ...
...stand outs whiter than the rest of the page, that looks a bit gray, like dirty. Same problem with a different toner. Anyone who have a pointer ? Still sounds like a bad toner cartridge. However, Try ...
Question about Panafax UF-790 Plain Paper Laser Fax
stand by, i have to wait for a few minute before it started to red blinks (13 flashes also stop for about 2 seconds and starts blinking again First if you have not tried it--unplug set and or cable or
Question about Kx-td1232 Super Hybrid Pbx Control Unit - V.1 & Kx-td196 Remote Modem
TD-1232 PBX - is is a programming issue or hardware issue? All of a sudden, one single line connected to our TD1232 has gone dead. I've checked with the phone company and all is fine. the number rings
Usually answered in minutes!
627 Questions
462 Questions
520 Questions
406 Questions
457 Questions