Questions & Answers for: rear wiper blade stuck position

...wiper blades on the right position and reconnect to the shaft and when I say the out put shaft is where the linkege connects to the wiper motor good luck if this information has been helpful please ...

...rear wiper blades are only 12" and all specs say 16". Anyone know where to find the correct length or part #? manual doesn't indicate and I can't find any blades that short> In Canada, Canadian ...

Rear window stuck down and the wiper motor is froozen in the up postion. So my computer thinks that the wiper is in the way and wont let me roll my rear window up If you can't the the master switch at

...rear wiper blade on a 2008 gmc At the mounting area of the blade to the rotating wiper arm is a tab that has to be pushed in and held to remove the wiper blade. The tab will be on the wiper blade's ...

...in an "up" position so I can't open my tailgate window. What is the cause for this frozen motor. remove a rear door cover, and turn on rear wiper and listen for motor noise, also check ...

...rear wiper blade Replace the blade and the blade holder. These days everything but the arm gets changed....and gone are the days of just replacing the rubber... I replaced my rear wiper with a ...

...rear wiper obstruction. Is there any way to bypass the wiper sensor to get the window up? Thank you! On some cars by winding down the rear window too far the wiper blades slip over the edge of the ...

...rear wiper does not work..I took the trim off and I am getting current to the module on the wiper motor. I disconnected the connector from a white module that is attached to the I haven't tried ...

...wiper blades are stuck in upward position,how do i reset them?? Replace the wiper motor. The module is built into it. And it has lost it's park position. If the wipers are delay type wipers the ...

2005 GMC SLT ENVOY rear washer wiper blade not working.fuse okay Pull the rear hatch and test the motor, they have a fairly high failure rated.