Questions & Answers for: Chevrolet Venture rear wiper arm

...rear wiper motor. I just replaced the wiper motor and the wiper blade does not touch the window on the upper quarter when the blade arm is vertical. suggestions? sounds like a bent wiper arm that ...

...rear wiper motor. I just replaced the wiper motor and the wiper blade does not touch the window on the upper quarter when the blade arm is vertical. suggestions? rear wiper moter making sound the ...

...wiper linkages were in the way - I just pushed it aside, but I also dremel wire-wheeled the corrosion off the terminals. I got at rear plugs with 1/2" drive with 1/2-3/8 adapter + 2" extension + deep ...

...wiper arm linkage. Detach the wire harness connector from the blower motor. Disconnect the motor cooling hose. Remove the blower motor assembly retaining screws Carefully pull the blower motor ...

...rear.remove the plastic shield and you will see the wiper motor.Remove the plastic top plate shield on the wiper motor.Apply a light oil to the plates and tap them lightly while cycling the wipers on ...

...rear wiper blade does not work and is stuck in an upright position. Turn it on - nothing. Push the blade down to correct position it eventually ends up back in upright position. Is it possible to ...

wiper motor) which is under a cover if you look left rear as you open the hood.Spray the plates with a light oil (wd40 etc) and tap them lightly as you cycle the wipers on and off.They should park now

...rear wiper blade is absolutely NO BETTER!! They all ****!! Anybody else dealt with this and come up with a solution?? I'd sure love to hear about it if you have. Thanks to all who read this, ...

...rear of the engine compartment and turn on the wipers and observe the wiper linkage and listen for the wiper motor noise.DO NOT STICK YOUR FINGERS NEAR ANYTHING.Turn off the wipers and turn key ...