Questions & Answers for: rear brake light doesnt work

...rear brake light on audi a4 need to replace rear brake light on 2003 audi a4 Inside the boot is a plastic cap embeded in the boot liner. Remove the cap to reveal a screw. Undo the screw and the whole ...

Ad

Question about 1995 Mark VIII

1 Answer

...Rear Turn Signal, Brake and Parking Lights Open the trunk and remove the luggage compartment trim. Remove the eight nuts retaining the reflector to lower back of luggage compartment Remove the rear ...

Ad

...Rear Wheel Anti-Lock (RWAL) brake system and 4 Wheel Anti-Lock (4WAL) brake system. The 4WAL system has two variations; a 3 sensor system and a 4 sensor system. The 2WD vehicles will be equipped with ...

Question about 1990 Econoline

1 Answer

...brake drum from the rear axle Fig. 6: Remove the parking brake lever retaining nut, located behind the backing plate Fig. 7: Disconnect the adjusting cable from the anchor pin, cable guide and lever ...

Question about 1996 SL

1 Answer

...Rear Turn Signal, Brake and Parking Lights EXCEPT WAGON Disconnect the negative battery cable. Fig. 5: Remove the trim panel fasteners - except wagon Fig. 6: Carefully remove the trim panel - except ...

...Rear Turn Signal, Brake and Parking Lights Remove the tail light assembly screws, then the assembly. Disconnect the twist lock socket from the lens housing. NOTE: To remove the bulb, turn the twist ...

Question about 1993 Century

1 Answer

...brake lights work, and my hazard lights work, but my running tail lights do not. I still haven't fixed and replaced my head light, so my best guess would be that the circuit for the tail lights runs ...

Question about 2000 FLHTCUI Electra Glide Ultra Classic

1 Answer

rear brake light will not work when brake pedal is applied, both front and rear brakes run through same sensor front brake applies rear light, but rear brake pedal doesnt. where is the problem? It ...

...brake light and rear turn signal doesnt I have a 2002 Ford Explorer. My rear turn signal light don't work and neither do my brake lights. My reverse lights use the same light and they work. ...

...rear brake light switch is hydraulic and it is extremely rare to malfunction in a closed circuit condition causing the brake light to stay on. Usually, rear brake light switch issues are caused by no ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...