Questions & Answers for: Reddy reached limit

won't stay running I can only keep it running with the cover off is this kerosene or propane. if kerosene, two types of ignition is used. a spark plug or a hot surface ignitor. the kero unit uses a ...

wont run I have a small propane reddy heater that will start fine but when i let go of the igniter the flame goes out. They suggest that u hold the igniter in for 15 sec. the heater will not run even ...

have john deere 50 kerosene space heater has fuel,new plug, starts by pushing the reset switch, runs for 20-30 seconds then shuts down with a loud click is equipted with a theromstart.I believe the ...

starts up and runs for 30 sec. and stops.yes it has fuel reddy heater find the high limit switch an replace or see if fan runs if fan runs then the limit is bad replace

MY READY HEATER STARS FOR 3 SECONDS THEN SHOUT DOWN This can be from either a bad connection from the thermocouple to the gas valve or it could be a bad high limit switch. If you run a jumper wire ...

I have a reddy heater 35000btu kerosene heater that continually shuts off on me. It is old but works well when running. I push reset button and it usually comes back on for a while but my shop isn't ...

I have a 225,000 to 375,000 btu propane heater that the gas valve will not open on. The igniter sparks I can see that .There does not appear to be a thermocouple unless it is built into the igniter. T

is the limit switch on acontractors kerosene heater the same as athermostat removed air filter and it runs .cleaned air filter and replaced. it then runs for 2 or3 minutes Not really, the limit switch

I have a Reddy heater RLP100. It will light easily but will not stay lit when you let off pilot It's either the thermocouple or the limit switch on back of burner, disconnect coupler and jump the 2 ...

Got a reddy heater pro 115 ignitor out mine doesn't use spark plug does this thing glow all the time while running or can you manually light these heaters Never try and light a furnace when you have a