...doesn't start, and there's no beep. Check your manual pg. 11 section 2.5. The 168-pin RAM go in the black slots ONLY. The 184-pin RAM goes in the blue slots only. Worth a check! Luck. Please
Question about ALiveNF6G-VSTA (MB-ALVNF6G) Motherboard
...the board to check if there is a problem with RAM Slot (As there are four slots on ur board). If no success, try using RAMs on some other system to confirm whether problem is with RAM or
...RAM to the other slot. If that works then the DIMM slots are OK, only match the FSB's.....sodeep OH dear sounds like your slot is on the blink try swaping them about or try to clean it but carefully ...
...please. thanks for it Sir. my regards my e-mail is : [email protected] There is problem in RAM matching. you just change the RAM slot. And then check the computer OR You should need Same ...
RAM Slot does not recognize more than 512MB ( 184 ) RAM Slot does not recognize more than 512MB ( 184 Pin ) ASROCK K7VT2 - PC2100 184 Pin Slot , put 2 1GB memory sticks in. Only recognizes 512MB from ...
...but their is no display on the screen smps and processor fan are working fine but no beeps of ram it can be the problam of ram only definetly your one slot is burnt..remove the ram and one by ...
...The TWO blue long connectors on the board with clips at either end are the ram slots, this model uses DDR1 ram, make sure you align the ram module correctly in the ...
...ram memory slots, due to too much pressure being applied to motherboard, while in computer case? Cracked motherboard at ram memory slots due to, user inadvertently had ram memory turned around ...
Question about G41MVS2 Core 2 QuadIntel G41DDR2A_V_LmATX Motherboard G41MVS2
...Ram slots . try one one ram if it is a Xeon processor you have to use in balance . if you put the ram s in a proper slot and listen for the notch lock sound . it should be firmly placed. And then try ...
Question about FATAL1TY Z68 PROFESSIONAL GEN3 Intel Z68 ATX DDR3 1066 LGA 1155 Motherboard
I reseated my ram and now I have no video output? Tried removing graphics card and running my display off of my motherboard and still nothing after resetting my CMOS. There is no single answer for u. ...
Usually answered in minutes!
227 Questions
138 Questions
103 Questions
99 Questions
77 Questions