Questions & Answers for: raise teeth sewing machine

...not pulling the fabric through. If the teeth have dropped and you do not have a drop feed lever you will need to get into the bottom of the machine and raise the teeth slightly and tighten the

how to raise and lower feed dogs If you do not have a button or lever near the teeth under the plate then you should have a raised plate

raise the teeth to the machine Your manual will tell you where your lever is to raise the feeddog, remember to move your handwheel towards you, never away from you when you want to raise the feeddogs.

...teeth will raise themselves next time you do regular sewing with a clunking noise - not really loud, but you can hear it. The feed teeth on my Des.1 are on the far right-hand side too so I think that ...

...teeth will not raise to feed the fabric. Refer to the instruction manual or contact the manufacturer for assistance in locating and operating the feed dog switch. Professional servicing: If the above ...

...Teeth do not raise, to low how do I raise them so macine will grab fabric Here is a link to page 22 of the manual. It shows you where to flip the lever to raise the feed dogs. If your feed dogs are ...

...teeth have dropped and I don't know how to raise them. Look in your owner's manual. I'm sure your machine has a reverse feed button but don't know if you can manually disable the feed teeth. ...

...teeth won't raise back up after sewing buttons Cleaned and turned machine on and off. It usually re-raises the feed teeth. The Sapphire will not raise the feed untill it makes one or two stitches ...

...wish to raise the feed teeth. The feed teeth will raise as you begin to sew. Look at #12 on page 2 here: ...

...2037 sewing machine and it works but the feed teeth lever is broken. I can't lower and raise the feed teeth. Any suggestions? It must be replaced; meanwhile you can use a flat wood stick to lift