...they may be worn.Also check your inner tierod end bushings.You have play coming from your steering rack or outer ends. check the power steering fulid level first,, if its full up its likle to be the ...
when i take off or when it shift there is a loud knocking noise coming from underneath the vehicle could be the U-joints on the drive shaft, get under car and move shaft back and fort, also visually ...
my 1997 mercury mountaineer is making an awful clinging noise when accelerating and turning changed constant valocity joints and u-joints and drive line still making same noise. any suggestions? Jeff ...
the left side tie rod seems to have slop on the rack & pinion side. Tie rod outter end is good.what is it? Worn inner tie rod joint,on the steering rack If you go to an alignment only shop, not ...
...skid marks light is on and check adv trac light light comes on and stays on. This began after the rack and pinion was changed. May be related my not. The steering wheel is also tilted a little to ...
...noise inside and a clicking noise outside Not sure about the squeaking noise, possibly the rack-n-pinion or a dry seal. The clicking is a CV joint or joint in the steering system needing ...
rust. I purchased the OE style 2-piece replacement, and installed it in the truck. I cannot get the rack end to seal in the rack, even though the clip and o-ring are installed correctly. The end moves
...at speeds greater than 30mph but not to right I had same problem with my 2002, and replaced the rack and pinion. Problem solved. It is NOT and easy thing to change
2002 mercury mountaineer power steering pump location I believe that is equipped with rack and pinion steering. Not a PS pump.
00 mercury mountaineer awd slack in steering where the shaft connects to the rack ..replaced ball joints control arms tie rods an the rack an the shocks started after u did all that feels like it ...
Usually answered in minutes!
658 Questions
555 Questions
524 Questions
377 Questions
323 Questions
