...stitch length. It should be set at 2or 3 for starters.Check the differential feed setting. It should be set at 1 or Zero. Put a piece of regular fabric under the needle without trying to cut it and ...
Question about Superlock 1934D Mechanical Sewing Machine
...stitch finger when done with rolled hemming. How do you put it back into place? Open the front cover and working table (the door that is on the left side). On the side of the needle plate is a ****. ...
...put the new spool on, knot it to the existing thread tail, turn tension to zero and pull it through and through the looper eye. At this point, you should have the two looper threads loose, lift the ...
...back, and of course the needle will break when it is put in incorrectly. Also have had problems of dropping the needles through the feed dog into the machine. Now i Put down a piece of paper over the ...
Question about 1034D Mechanical Sewing Machine
...put it back into place? That would be my first thought, the top and bottom blade move against each other cutting the fabric. Rolled hemming usually requires the blade to be set on about 2, or middle ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions
