belt to put the alt in well has soon as you loosen and take out the alt the belt will become loose then put alt on it will slide down to put belt around and then pull up on alt and tighten it up b2200
BELT. PUT THE NEW BELT BACK AND WITH THE HELP OF PRY BAR PULL BACK THE ALTERNATOR AND WITH THE BAR IN PRY TIGHTER THE NUT AND BOLT. CHECK FOR THE BELT PLAY BY PRESSING THE BELT ON THE AREA MID OF BOTH
Question about 1991 323
...put belt back on wrong had to replace the water pump on a 1994 mazda b3000 pickup. after putting all the hoses and parts back on when finished i started the engine. it started making a very loud ...
...to put a wrench on it to losten it up putting thr new belt on two people come in handy here put belt on as on diagram or yours and relesase the idelar arm slowly it should be very tight after
put tension on the belt by adjusting the alternator so that you have about 1/2" of play in the belt when you pull up and push down on the belt. If after you tighten and start the car the belt squeals,
put a new timing belt on, car still wont start. Timing belt and alternator belt broke while i was driving. put new belts on, car still wont start. any suggestions? hi put the #1 piston up with the ...
...put the belt on as far as you can until you have no slack left, put a wrench on the tension pulley, pull the wrench until the arm moves causing slack in the belt and finish putting the belt on the ...
...belt i put anew timing belt on and it seems to be chattering o posit side of tentioner replaced idlers and tenioner is some how the belt not on properly Did you install a new bushing with the ...
Question about 2000 Protege
...put a new water pump pulley, 3 alternators. My car is still breaking belts. Its breaks the most belts in the winter when I cut on the heat. Now its starting to break belts on a weekly bases. Replace ...
Question about 2000 Protege
put on a new water pump pulley 3 alternators and several alternator belts. make sure that the pulleys of all the driven equipment are in alignment and not at a bit of an angle to the axis of the drive
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions