...ink pump on the left hand side. Remove the left side dark grey trim, then take out the screws to remove the left side panel. You will have to use some force. I slightly damaged the plastic because I ...
Question about RZ220 Duplicator
ink pump and test This is unlikely that the pump is not working.. I have 2 RP 3700s.. The screens are probably clogged.. with old ink.. or there could be a fit problem with the ink tube to the drum..
Question about Photosmart C6180 All-In-One InkJet Printer
...pump failed Check the INK nozzels to see if they are clogged, Use a q-tip /or several to remove the ink in the nozzels, then check the ink jets where the ink makes contact with the paper, and clear ...
Question about MultiPASS MP390 All-In-One InkJet Printer
...ink pump jammed up. Make sure waste ink pump rotates freely, after cleaning. Clean the waste pump-hose too! Waste ink pump is located under head cleaning system. Short solution: 1.Take apart and wash ...
...and inking hose. 4. Malfunction on pump motor. You should verify all those item by dismantling those parts. Just replace any of those parts your drum will surely pump ink again. Posted by: ...
...do "Maintenance" and you hear a whirling noise --- that is the ink pump spinning to try and pump in ink to the print head. If all fails you may have a bad printer out of the box. Hope this helps, ...
...pump pushing pressured air in to the cartridge bank to force ink out through ink tubes tubes..During this process any leak at the cartridge neck or blockage in cartridge needle causes leak. ...
Question about Designjet 4000ps InkJet Printer
...code is from the ink dispenser pump saying it has reached the specific number of pumps for that particular ink cartridge. Once you change out the low ink cartridge the pump will automatically
...DX 4542 not supplying ink Ink pump motor may be not working first you need check your cp is original.. After that remove drum unit disabled the unit and clean ink detection sensor and ink pump ...
Question about Designjet 4000ps InkJet Printer
...pump the ink flowed through okay. Also when reassembled and back in the machine running programme 882 in test mode I could hear it working. After I'd done that and running programme 887 the drum had ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions