Questions & Answers for: Kenmore pulley belt

.....install belt on small motor pulley first then work around drum pulley while turning large pulley try spinning by hand first to verify belt is tracking in center or close to center of large ...

belt and pulley on floor. Got a new belt. Can't fiqure I how to put pulley back on with belt correctly. Any way I've tried still won't spin tub. I can spin by hand. Dryer puts out heat,no spin. I have

...belt under the pulley inside the idler, raise up on the idler, loop the belt on the motor pulley and let the tension hold as shown HERE I Was killin' myself over this. The thing on the bottom is the ...

...belt but i also notice there is a pulley lying on the base unattached, i dont know where this pulley goes. The pulley in question is likely a spring loaded idler pulley, used to keep tension on the ...

...the motor pulley (this should force the idler pulley to "open up" and add tension). With the belt and idler pulley in place, it should look like this... Let me know if you still need help. Good

...belt on the smaller pulley first and then start it on the bigger pulley on one side and then turn it onto the bigger pulley by spinning the pulleys to get the belt to direct itself onto the larger ...

...belt on the motor pulley,that's it,picture this,fold your pants belt so both sides are touching,now grb the belt with two fingers around four inches from the end of belt and pinch it together,your ...

BELT ON LARGE PULLEY AND TAPE BELT TO LARGE PULLEY TAKE OTHER SIDE OF BELT AND STRETCH TO MOTOR PULLEY WHILE ROATING LARGE PULLEY WALKING BELT ONTO SMALL PULLEY OR LOSEN MOTOR BRACKET PAY ATTENTION TO

belt. The idler pulley/tensioner fastens into two slots in the base of the dryer to the left of the motor . The belt goes around the drum then through the idler to the motor pulley ,you have to make a

...you can not get belt on belt makes an S on small pulleys one of the pulleys is the motor most belts are grooved flat side to dryer drum grooved to motor pulley flat to tensioner pulley do not flip ...