Questions & Answers for: pu board

...get tv from stanby mode (red light) to on (blue light) Pioneer Plasma Model PDP 5070 PU I would assume the power board has a problem. A tech could possibly repair it without replacing the whole

...PU unit fan motor 1. Is fan in PU operating? NO - Replace Fan motor. YES - Replace engine control board (K7N). 2. Error reoccurs after replacing fan motor. YES - Replace engine control board

error120 this error is a PU Board Fan motor error. Either check that the fan at the back is connected correctly if not replace the fan. This should fix the problem.

1992 nissan pu instructions to replace clutch many many many steps involved. too many for this board. get a repair manual on eBay for about 5 bucks that way you will have a hard copy and pictures.

err 120 This error is a PU Board Fan motor error. Check if the fan is properly connected, if necessary replace the fan. Should fix the problem.

error 120 This error is a PU Board Fan motor error. Check if the fan is properly connected, if necessary replace the fan. Should fix the problem.

...PU error code displayed. I have already tested the drain pump motor, and cleaned out the filter, the problem is still happening. Please help, Dan When all else fails its usually the computer. There's ...

...pu. Why does it keep shutting off? it goes on for 15 min to half hour and it turns itself off Short circuited component/s at its internal circuit board. Contact any service technician. If the main ...

...board water damaged. cleaned and power on. power light on. no fan working. but battey is charging pu-600 and pu 500 tested. no power out properly out 0.5V but UH1 chip is heat up. heavy. pq 500 out ...

...pu. I would like to verify the part number on the main board. But, I cannot remove the back panel. Is there a special tool i need, as i have only found two screws? My tv will continually cycle power. ...