Questions & Answers for: Nakamichi proton wiring

need new 8 pin power source wire from receiver to subwoofer Recently, my electrician spliced the power wire that travels from the receiver to the subwoofer. It wasn't long enough and they were not ...

Need a Nak CD-45Z wiring harness, or diagram I just got a used CD-45Z in excellent condition. However, it didn't come with the factory 14 pin wiring harness that plugs into the back of the head unit. ...

Nakamichi RE 10, Ser # D14104843 I just picked up this unit. How do the speaker output jack inputs operate? Do I just stick the speaker wire in the hole and tighten them down? Or, do I have to install

Wire antena (that came with SS5 system) causes a hum The wire antena which came with the system (and instructions were to extend the wire for its entire length) causes a hum. If I turn the interphase ...

Switching the ignition off loses the preset stations I recently installed a nakamichi CD-35Z in my MGB (no manual) The acces lead is connected to a non switched positive voltage source but I still ...

...involve isolating the sepakers one by one. To do that you need to get the sepakers tested. Thanks ...

NAKAMICHI CD 45Z installed stereo, everything working correctly but no sound If you are using the speaker out wiring (not RCA) then disconnect all speaker wires. connect only one speaker or use a ...

Hum form both speakers, and moving the speaker cable where it goes into the console starts/reduces/stops the hum. Any solutions out there? Is there a ground wire broken in the connector? Had this ...

it reads the cds but there is no sound are you running audio through an amplifier? if so, you may be using the wrong blue wire to turn the amp on. usually the amp remote wire is blue/white. solid blue

How do I attach banana plugs to my receiver's binding posts? I can't put the banana plugs through the center of the post's knob. There is nothing to receive it. if It can't be done, can I replace the ...