Question about 1986 CB 700 SC Nighthawk
...clutch isn't working on my 86 vt700 shadow, my guess is I need to bleed it out. How do I go about doing that? My guess is that unless it leaked out, your master or slave cylinder is going out. But I ...
1986, VT700C shadow, clutch doesnt work I have been restoring this bike. It sat for 4 months while all metal parts where being chromed and painted. got it back together and started it. The clutch ...
...clutch dried up,slave cylinder still wet, how much trouble to rebuild master cylinder? This is on a 650 Night Hawk 1983 Why do you think you have a problem with the master cylinder. If it is dry it ...
1972 Honda CB750K2. Clutch started slipping at high speed (over 75mph). No noticeable slipping at lower speeds even when punching it through the gears. Also has a slight chatter when sitting in ...
...clutch it will not pull in all the way ...has fluid... checked slave cyl it was stuck cleaned it freed up bleed system and was stiff again and will not operate clutch.checked clutch plates all seems ...
...ideas, can you help me ? Check under the valve covers to make sure the rocker/cam bay is draining properly back to the crankcase. Open any clogged holes. Aside from that possibility, I'm stumped
...clutch master cylinder, Put a plastic sheet and a rag under the banjo, pump the lever a couple of times till DOT 3/4 brake fluid starts pouring out past the sealing washers. You have now gotten the ...
...clutch lever, and when i bleed it, it just barely squirts out any fluid, shouldn't it squirt out pretty hard once you get rid of all the air in the line? and as long as master cylinder is working ...
Question about 1985 CB 700 SC Nighthawk
fluid level in clutch master cylinder. If level is too low, after adding fluid, bleeding the line may be needed if the clutch still doen'n't function correctly- see manual/get specific instructions on
shifting 1 to 2 gear hard shifting Hi, Anonymous and the usual suspects are: 1. Clutch not adjusted properly. 2. Primary chaincase overfilled with lubricant. 3. Corners wore off shifter clutch dogs. 4
Usually answered in minutes!
57 Questions
26 Questions