...Fill the reservoir to the proper level with the required fluid. Attach the J 43485 (Adapter) to the J 35555 (Mity Vac), or equivalent. Brake fluid will deteriorate the rubber on J 43485. Use a clean ...
...and transmission doesnt have a oil fill check stick take it to a transmission shop to check the fluid from under the car and add if needed what you are feeling is called slipping and it IS ...
...clutch in the bottom of the pan (sooty looking deposits are normal), clean the pan, clean off the gasket surface, install the new filter, put the new gasket on the pan and start inserting the bolts ...
proper gear? Or, does my vehicle have a lockup torque converter that is malfunctioning? If anyone has had a similar experience, your help would be much appreciated. Thank you, Brad Likely, you ignored
...up from the floor before you feel it engaging.The oil fill check is either at the speedo or a plug at the axle shaft level.Be sure to use factory recommended fluid.Gear oil is not a proper
...proper level, the system should eventually expel all the air. Hope this helps. Good luck. Sounds like what you are hearing is air in the coolant hose's. Try this...after letting the car sit all ...
...fluid Open the cap and fill to full mark with recommended proper fluid, usually brake fluid. The reservoir is usually on the firewall or close to it, looks like a little bottle with a cap on the
...Fill the clutch master resevoir will the proper fluid then find a cap that fits the resevoir or buy a replacement cap and drill a small 1/8" hole in the middle of the cap then use a vacuum pump and ...
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,435 Questions
1,496 Questions