...not finish a wash,then the programme selector knob keeps turning,then the on/off indicator constantly flashes. open the filter on the bottom of the machine (water will empty out). Clear any
Question about Ariston AWD12 Front Load Washer/Dryer
Programme Selector knob keeps turning. - Airston Margherita AB95 The programme selector knob keeps turning. We have tried the troubleshooting it suggests in the instruction manual, but this has not ...
...programme selector knob keeps clicking over clockwise. is it just a faulty switch? No it is not a faulty switch, it is the selector switch going round because of another fault on the washer, it is ...
Question about Nextra HNWL 3136 Front Load Washer / Dryer
...it onto stop then resetting it - it seems that this can go on for ages - last time it took me ten minutes to get the right programme up - is there any advice you can give me. Faulty selector knob
Question about Ariston AWD12 Front Load Washer/Dryer
...AW-12 Washer/ Dryer, Programme selector knob just turns and turns after wash cycle instead of going into a spin. Please help. Regards Ben it sounds like the nob is striped try replacing the
selector cycle knob. I have to keep advancing the knob through the cycle of wash just one click does it well for about three advances in the rinse cycle. Could be a bad dial or cold water problem. How
selector knob to a dot, or any off positionTurn the washing machine back on and watch for rapid flashing on the neon lightTurn the washing machine off and select the new program (or maybe spin)Turn it
Question about W 123 Front Load Washer
programme selector knob it was free moving and had a notch effect at each The knob used to move freely but now it is sticky to move around also the buttons that select temperature, spin speed etc seem
programme selector one position to the right (clockwise) Continue to hold down the START/PAUSE and option buttons until the LED begins to flash (at least 2 seconds) In the first selector position, the
Question about W 123 Front Load Washer
...selector knob needs to be pulled back out in order for it to go into the rinse cycle. Once you pull the knob back out to start the rinse cycle the washing cycle finishes on its own. Any help would be ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions