Questions & Answers for: procurve lights

...s that we have do it? thank you so much for any help you might be able to offer. Hi Tculver, I have ProCurve 2424, 2524 and 4000/8000s so I can?t really address your direct question but I may have ...

...from a Lucent DSL-HS-2.3MBS to a Westell 6100 modem, using the same cable to connect to our HP ProCurve 24x10/100 Mbps but now our network is SLOW but the we're clocking over 7mbps on speed test ...

...procurve switch supports? It is not a distance limitation of the switch, rather the cabling in the walls and ceiling. If the cable is Cat5 it can be up to 100M, but this can be drastically reduced ...

...Procurve switches and my configuration allows for each switch to see the other however I can not see the personal computers attached to the switch. Any ideas? The only thing you can see is the arp ...

I need to do a console connection to a hp switch, how to console inot a procure switch You should have gotten a cable with the switch. If you have a light blue Cisco cable, that will work. or you can ...

fault light is on, all else looks normal and chassis fault light is on, all else looks normal and green. u can change the settings in bios to light off the chasis fault light. restart your system then

...1at the bottom left side of the switch is also blinking. Power Supply #1 is faulty. Contact HP ProCurve Support at 1-866-my-procurve for support and possibly

fault led glowing on hp procurve 2650 operate a factory reset to make sure it is hardware Fault: press reset and clear simultaneously for 3 good seconds then release Clear, when Switch fault and ports

PoE indicator light turns from Green to Amber when I plug in a PoE phone. phone does not come up but will in another switch. Set-up is the same on both switches. 2610-24PWD J9087A How much power is in

default password i need to know the default password foor hp procurve 2626 there is no default password on an HP switch. You can clear the password on a switch by powering on a switch and make sure it