Questions & Answers for: pro cut 25 plasma

Go to start cutting and the safty light comes on and shuts the unit down. What am I doing wrong? Make sure the ground is attatched and its completing the circuit. i had the same issue with mine and ...

...PRO-CUT 25 PLASMA: all settings ok, air ok will spark on occassion and then nothing. tried everything put will only lit very seldom and then nothing.???? probably 15 hours on machine now nothing/ can ...

start cutting and the safety light comes on Usually it could be one of two things. The first thing to check for is to look at the contact and make sure it is not melted down and ensure its in good ...

...it should cut. i barely getting through 1/8 brass. is it because i have it on a extension cord? Probably. Extension cords make a BIG difference. Try plugging it directly into the

Pro Cut 20 cuts about 2 seconds then quits. I have 110 pis, 60 gal. compressor, plenty of air. Set regulator on machine @26 psi. Lights, cuts, quits almost exactly 2 seconds every time. Is your ground

on lincoln 25 plasma cutter There should be a electrical board in the rear under a cover. There are different configureation of some jumpers that can be changed. The diagram should be inside the cover

need 2 capacitors for my plasma cutter 1500uf 240v the capacitors 0n the board are blown Need to replace 2 Kendall K05 105c 0305 942 1500uf 240v Hi, can you send me pictures of the caps, all sides. ...

...with it at operating pressure. an anyone help please...... I don't see it in the manual ...

i have a pro cut 25 serial # I2 04 03 01322 what do i have to do to switch it to 220 volts There should be a small red switch on the back, you can switch it there.

...pro cut 25 i would like to change it from 110v to 220v serial #i2 04 03 01322 The pro cut 25 will run on ether 110v or 220v without changing anything. I made a 220v to 110v adapter. It works well and ...