Question about PIXMA iP4000 InkJet Photo Printer
...printhead alignment, printer said : there was a fault with alignment process press resume button try again (tried again, same problem) suggested try manual alignment, did this then black and yellow ...
...Printhead , and then click Clean . Step five: Align the printheads If the print quality is still bad, align the printheads. Make sure the printer is loaded with unused white paper. Open the printer ...
Question about Officejet Pro L7780 All-In-One InkJet Printer
...printhead, the printer automatically aligns the printheads to ensure the best print quality. If the printer does not print the alignment page automatically, start the alignment process manually. To ...
...Printhead Alignment." After the alignment has finished, print an "Image Quality Print" to verify the printer?s output. Ensure the printer is loaded with minimum ?A3" size media and is at a READY ...
...printhead alignment after installing. if you are unsure about how to do this, go back to the support page above and search for align printhead. There will be step by step instructions for this too. ...
Question about OfficeJet 7410 All-In-One InkJet Printer
...printhead.Make sure the printer is loaded with unused white paper. Open the printer Toolbox , and select the Printer Services tab.Click Align Printheads . The Align Printheads window opens. Click ...
...printhead latch Close the cover. Figure 9: Closing the cover The printer should align the printheads automatically in a few minutes, printing an alignment page. If it does not, go to the next section ...
...click Settings , and then click Printer Toolbox . Select the Services tab, and then click Align Printheads . Figure 10: Align Printheads The Align Printheads window opens. Click Align . The ...
alignment problem. just refilled black ink cartridge..seeing message that printer is not aligned and remove tape from cartridge, but i see no tape 1) remove the cartridge and check it is not leaking. ...
...drive gears for damage. Ensure the gears are correctly aligned and homed. Check the nose cone alignment on the X-Axis motor. Is the nose cone aligned with the printhead shaft (left/right
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions