Questions & Answers for: print carriage moving centre

print carriage will move across to the centre of the printer. Remove your ink tanks (same way you always would) and the place where the cartridges sit is actually your printhead. To remove it you need

print cartridge that passes out the ink. 2. slam to the right : if i am not wrong this is the carriage you are referring to. Do the following steps (though i presume you might have done it if you have

...carriage moved to the center. So after that I closed the "door" and it works properly now. ...

print job to the printer and while it is printing unplug the power. That would stop the carriage assembly somewhere in the middle but if it is not moving to the center on it's own you might have other

...carriage to the correct position to replace the ink cartridges, or in print manager of your operating system, if not than you can cheat by powering on the printer and when the carriage unparks (move) ...

carriage positiond itself between the centre and the nook where it normally should position itself, move from there and do the printing. and of course the yellow light keeps blinking, and of course no

...carriage normally parks itself). You will see the purge unit. look on it to see if there is any paper stuck on it. It will be soaked in ink. Remove the soaked paper and perform normal cleaning once ...

carriage normally parks itself. You will see a couple of sqaure pads with a wiper blade.Remove any paper that you may find there. You can also prize out the pads and wash them in water. refit the pads

...print head carriage toward the middle to get it out of the way.  Then when the print head carriage is out of the way you want to take a Q-tip (in fact a dozen or so will be needed) to clean up ...

..."button" that sits on print head carriage....this will release the print head from the cradle....to re-attach just press the cradle towards the rear of the carriage using the target icon as a