Question about PW2102 Gas Pressure Washer
...pressure in hose and stalls engine Last time I tried to use the washer I had had to keep the trigger pulled on the gun other wise it would build up to much pressure between the pump and the gun and ...
Question about PW2102 Gas Pressure Washer
pressure washer stalls out when wand nozzle is released cannot pull start cord unless wand trigger is depressed. if I release wand trigger while pressure washer is running the engine stalls & shuts ...
...WASHER RUNS PERFECT, WHEN WATER COMES ON, IT STALLS. BUT IF YOU PULL TRIGGER BACK ON WAND, THEN SPRAYER WORKS. THE MINUTE YOU LET GO OF TRIGGER, IT STALLS OUT. hi you have got a fault with the ...
Question about Briggs Stratton 2550 Psigaspressure Washer
stalls from the pressure build up and if I keep the trigger squeezed it will pressure wash for about 2 seconds then quits putting out any water from the wand and engine starts to bog down??? May be it
Question about Briggs Stratton 2550 Psigaspressure Washer
Engine idles down and sometimes stalls on pressure washer when trigger on wand is pulled clean out the carb fuel turns to **** after about 30 day for small engines
Question about Briggs Stratton 2550 Psigaspressure Washer
...Pressure Washer Model PCH2401 I have this pressure washer and it stalls the motor out a after using for 10 minutes or so. I tried to start it again and it was hard to pull.I disconnected the water ...
...pressure washer I had a bad pump so I replaced it with a new one. The motor starts when you pull the trigger it stalls the engine, it seems to have pressure but quits right away It's the spark plug ...
Question about PW2102 Gas Pressure Washer
pressure washer has only been used 6 times over 6 years but there is no high pressure. In fact when I pull back on the wand nozzle to activate the high pressure the engine usually stalls. Help! run ...
Question about PW2102 Gas Pressure Washer
...pressure washer that stalls as soon as I turn the water on. I have replaced the pump with a brand new one that does the same thing. It also has a new carburetor, fyi My neighbor has one that will do ...
Question about PW2102 Gas Pressure Washer
...pressure washer stops running when i pull the trigger check for a blocked main jet in the carby the principle is that when the trigger is released there is no pressure in the pump so the engine is ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions