...pump shaft, just a shim and a copper washer, the rest was down to good tolrences, your after market pump may have poor tolerence between the pump body and the shaft, pirate parts are not always a ...
...1985 ford F250 oil pressure is good when first started after 10 min oil pressure drops off the guage Sounds like your oil pump is bad or you have a bad sensor. How many miles are on this truck
Question about 3100 PSI 2.8 GPM Gas Pressure Washer 020490
pressure washer. I see a yellow oil plug on both sides. Hi Andy. The yellow oil plugs are for the motor. At the bottom of the crankcase you should also see a screwed drain plug. Remove this, allow the
Question about 3100 PSI 2.8 GPM Gas Pressure Washer 020490
...remove hose from water pump-Husqvarna model 020490 power washer Use pliers an next time don't gorilla it on there. The rubber gasket doesn't need super strength to tighten it enough to do its ...
Question about 3100 PSI 2.8 GPM Gas Pressure Washer 020490
...pressure washer for more than a few seconds without pulling trigger. Rebulid kits are available however todays chinese junk pumps quit rather quickly. order a new pump on ebay and read your owners ...
Question about Original Sears Craftsman Husqvarna Part 173288 LINK FRONT ASSY
DO PRESSURE WASHERS NEED PUMP OIL? most do but it depends on the make and mode of your pressure washer
why do i have low pressure? Maybe sucking air in through a chemical valve (if it has one) maybe new pump seals a valve suck open in pump. worn lance jet. www.Flowjet.co.uk http://www.flowjet.co.uk/
Question about 3100 PSI 2.8 GPM Gas Pressure Washer 020490
pump leaks when pressure washer running Where is it leaking from? Mine leaks from where the brass part connects to the alluminum part of the pump.
Question about 3300 PSI 3.2 GPM Gas Pressure Washer 020524
...pressure washer, not even with pressure of water off was pressure washing drive way, it cut back twice, then cut off. I tried to pull the cord it want move.it doesn't matter wheather the water is on ...
Question about 3300 PSI 3.2 GPM Gas Pressure Washer 020524
...pressure washer to start running. Can pull the start cord but engine acts like the switch is off. New gas, new oil, new spark plug. I've taken the carburetor apart, cleaned it, and cleaned the float ...
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions