Questions & Answers for: Honda pressure washer locked

...pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to ...

13hp honda on hyd. wood spliter running normal at 13hp honda on hyd. wood splter running normal at full throtle on knock or noise the engine stopped very fast dead stop.tried to restart rope locked ...

starter cord wont pull I cannot get the cord to pull more than a few inches before it locks tight and will not pull any farther. won't start Try removing your spark plug, you could have fuel on top of

...pressure washer starts (most of the time) but if I shut it off to answer a phone call, etc.,I cannot get it started again. It's like it has a vapor lock or something. Any ideas what is wrong, ...

...pressure washer by lulling the cord, there was sharp popping noise, and the engine would not crank to start. It is a Honda K. washer. What went wrong? Pls advise, thanks. Make sure your oil level is ...

...pressure washer. The part doesn't slip back over the ball bearings. What am I doing wrong? More than likely you aren't doing anything wrong, try putting some grease on the o-ring inside of the quick ...

power washer shuts off during use after 15 or 20 minutes Could be problem with fuel lock if your engine was designed for California standards. New style fuel caps tend to cause fuel lock by not ...

pressure washer power boss 3000. I load the gasoline, start the machine, but pressure water is not coming out from the trigger. i tried so many things , but can t get started. Hi!! Some guns get stuck

how do I keep wand from blowing off trigger the wand will blow off the trigger and I cannot tighten it up so it won't do that. Push it on and turn it, it should lock in place,

...Pressure Washer. The pull cord locked up. pressure washer Honda GCV160 pull cord is locked up? I have been lucky to resolve the issue in two easy steps following some internet advice. Leaving aside ...