...trigger it dies. And it will not restart when it is hot. likely you air to fuel ratio is too lean, runs mean and hot but under load dies. then floods the carb. when it happens pull the plug , kill ...
Question about 2500 PSI Pressure Washer
Pressure washer sputters and stalls when trigger is engaged Have used this pressure washer for years with no problems other than trigger assembly replacement, and have used it well since the ...
Question about 2000 Psi Gas Pressure Washer PW2002
...pressure-engine dies when letting off trigger I am afraid that is how they work even electric ones wont start unless you squeeze the trigger ,once they are running you should be ablr to release the ...
Question about DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer
...pressure washer it stats right up and while i was cleanning the wood fence i let go of trigger during about 10 min, and the motor started dying i pulled the trigger and it pick right up again any ...
Question about Power Products 1539 Pressure Washer
...pressure washer stops running. Runs fine as long as trigger is depressed. What could cause this? When the trigger is pushed, the engine is supposed to rev up to increase the pressure. So from the ...
Question about Black Max 2600 PSI Pressure Washer
pressure washer. Trigger must be pulled and held while starting. After starting the sprayer works OK but engine lugs down and dies as soon as trigger is released. Anything I can do, or need to take to
Question about Generator 5987 2,500 PSI 2.3 GPM Gas Pressure Washer
...pressure washer will not run unless trigger is pulled to start pressure washer you must hold the trigger in. when you release trigger, engine dies the pressure regulator is stuck inside the pump ...
...to around 500 psi. Try this YouTube video: https://www.youtube.com/watch?v=WfUcXlBZRxk or this; ...
Question about Generator 5987 2,500 PSI 2.3 GPM Gas Pressure Washer
pressure washer, part #580.752700 dies when trigger off. Installed fresh oil, new gas, cleaned air filter and carb and all worked great for a few times. Then started to die when releasing trigger. Now
Question about Generator 5987 2,500 PSI 2.3 GPM Gas Pressure Washer
...pressure washer I pull the trigger water comes out for a few seconds then its like your constantly pulling the trigger on and off. it dies then fires back up and so it goes on and on. its a black and ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions