Questions & Answers for: pressure flex

flex hose) If you have pressure and the icemaker is cycling, (arm moving up and down on its own) you most likely have a defective water inlet valve. This is the valve that the supply line connects to.

...pressure spec for a 2004 tahoe with 5.3 flex fuel. I have low power. Changed fuel filter, air filter and oil and still no power. Checked fuel pressure and had about 43 psi. not sure what spec is but ...

pressure related? If the gas flex line to the unit is to small it will whistle and make a very strange noise while the main burners are on. The gas flex is what connects the unot to the hard piped gas

...pressure line to 25 ft. lbs. Snap the flex coupling shield into place. Fill the steering reservoir. Run the engine and turn the steering wheel lock-to-lock several times to expel air. Check for

...applied and will release when bleeder bolt is opened. The problems only occurs when extreme pressure is applied to the caliper ? Your flex line rubber line is got a blockage replace rubber flex

...on the affected one if fluid comes out under pressure and the caliper then frees (wheel would have to be off ground ) the flex hose could be falling apart inside and pluggin up.Replace flex

...flex plate is broke..only when put pressure on it.could it be CONVERTER only does it when putting under pressure.took the tranny out and was not a broke flex plate. it could be, since you have the ...

...pressure range you need to be in. One for NG and the other for LPG. Use a manometer to check the WC. The main reason I decided to post a second answer, is IF you used flex gas line, this too will ...

...that applies pressure to the flex shaft maybe it has gone bad, sometimes the shaft housing slips away from motor enough that flex shaft will not reach the head and the flex shaft could have

Flex ice Machin 404a gas ..how much suction and discharge pressure should be..? The ideal suction and discharge pressures for a Flex Ice Machine using 404a refrigerant can vary depending on several ...