No power My Sherwood Newcastle R-945 turns itself off after 3 sec. when I have just turned it on. disconnect everything from the unit and see if it still does it. if it does i would check the output ...
no power just standby light, no clicking The Sherwood R-945 has at least 6 fuses inside - any one of them could keep the system from powering on properly. The lowest power fuse is rated at only 35 ...
sherwood rx-4109 power shuts off i've made the proper connections to my sherwood rx-4109, but as soon as i turn on any component the receiver shuts off. in the beginning i thought it was the timer, ...
Question about RX-4109
When the power is swithed on as soon as the tuner or auxillary kicks in the power shuts off. When i switch the power on as soon as the radio or ausillary kicks in the power shuts back off. TAKE THE ...
...could be a problem with the amp in this case though... just a problem when it is trying to put power to the speakers. This problem is related to a bad diode in the power circuit. test all diodes ...
...unit off I lose all the speaker level settings and have to reset them Some recievers have both a "power switch" and a "stand by" switch. Here is the difference. "Power switch" eliminates all power ...
...shut off stereo protect mode? How can I do this? It's a Sherwood RD 7405HDR Receiver. Protect mode is on because something in your speaker wiring is wrong, or you have a broken speaker, or it's ...
Question about Rd-7405hdr 7.1-channel 70-watt Dual-zone A/v
...after a month it shuts off after a few seconds what is the problem? There is a short either in the power supply or one of the output channels. Receiver is shutting down to further protect other ...
Question about Rd-7405hdr 7.1-channel 70-watt Dual-zone A/v
...that when turns on stays on for approximately 4 seconds and then shuts down. Sounds like you have power supply issues, pull the cover off and see if you can see any bad capacitors for ...
Usually answered in minutes!
43 Questions
37 Questions
45 Questions
19 Questions
27 Questions