Questions & Answers for: Pontiac Sunfire power relay

...relay exposing the legs a little and check for power on each leg when the car was running and the temp was up. It had power on every leg except for the leg that ran to the fan. Could it be that both ...

...Relay Location? Not it the fuse box near the batt. The Relays (3 of them) are located behind the Battery... between Battery and Fender, inside a Box call Inteligent Power Distribution Module (IPDM). ...

...switch and also the relay.it seems the relay is letting power stay to starter,if i tap on relay the starter quits . Change the relay with a new one. The contacts maybe is sticking because it is

...went off most likely the fuse or the relay for them. CHECK FOR POWER AT LIGHT SWITCH IF NO CHECK FUSE AND DRL RELAY.IF POWER GOING TO SWITCH IT COULD BE OPEN OR YOU HAVE DIMMER SWITCH

...relay is working, is there power at the connection to the pump. If not then the wiring is broken. If there is then the pump needs to be replaced Hi Brandi,Something I've recently learned, check ...

...relay box isnt getting power you need to follow the power lead until you find power again. once you find power the issue will most likely be obvious, like a bad connection or loose ground..hope this ...

power (It is new and so is the relay), We determined the fuse box under the hood at the location in which the relay for the fuel pump is located not getting power. We hard wired it to the battery, and

...blower motor and it runs, I would say its the blower relay or the control switch on the dash. The control switch provides power to turn the blower relay on. The fan switch provides the ground

power to fuel pump, as well as ground wire that control pump. when you say relays are good do you hear them activate when you turn key on , switch relay out with knowen good one .,you can try a little

...relay get its power Which pin at the relay socket , pin 85,86 or 30 ,87 ? Here check out this video ! GM Fuel Pump Relay Testing The fuel pump relay requires 2 power sources Joe. One terminal will ...