the power for the fuel pump directly to power and see if it works if so examine that you have power from the ignition switch and a ground to energize relay and that power is good on feed side of relay
...power) Relay, the RAP relay also supplies power to the radio. The RAP relay is also fuse protected by the RAP fuse in the under hood fuse block. The RAP relay is energized by the BCM body control ...
...relay power terminals. You should read infinite resistance; otherwise, the contact points are shorted. If this is the case, replace the relay. Connect the end of a fused jumper wire to the positive ...
relay, no power to the motor, you have a bad relay. If the relay is not receiving power to the coil, then check your switch. You need a voltmeter, Radio Shack has them for very little money.Hope
Question about 1999 Camaro
...power to relay port but none back at the pump you need to check the relay for both power on the control side and the switched side you should get a 2 second pulse from the ecm when the key is turned ...
Question about 1999 Camaro
...power to relay and used jump wire to pump prime wire pump works w 93 chevy caprice 5.0 new fuel pump changed relay and fuse still can't get pump to work can't even get relay to click ...
power If the relay is getting no power that's the problem. There are 2 sets of power going to this relay, the control signal (the power that comes from the switch on the dashboard turning on the relay
Question about 2002 Blazer
...relay is bad on the power side. try to exchange the relay with one other of your fuse box . If it works fine with other relay change the relay and you'll be on your way. Just for you to know!!! Here ...
relay, gives power or ground electronically to turn the relay on giving power to the fuel pump through the fuel pump fuse. You could have a bad relay or an anti-theft system problem . What engine does
Question about 2006 HHR
...has proper ground and power. Also check to see if switch side is transferring voltage to relay to engage relay. The relay is designed to relay power to an device so switch assembly does not burn
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions