...panel is damaged and will have to be repaired. If any power line connections were broken or are suspect, I hope you have contacted the power company. Either way, I would test any affected outlets to ...
...Control Panel biscuit AP3038852 Membrane Switch AP3033666 model # MH6150XLQ LOST POWER. I CHECKED WALL RECEPTACLE. IT'S GOT POWER. MICROWAVE IS DEAD. NO LIGHT..........NOTHING. WHAT'S
Question about Spacemaker JVM1640SJ Microwave Oven
...the fuse you have to disconnect the power to m/w, take the upper grill off, take the screw on top of control panel, lift the control panel up and removed. The 20 Am fuse located behind this
Question about DCM24 Convection/Microwave Oven
...power or lites on panel.It will not work.Could this be a panel replacement like on the JennAire range? Welcome to Fixya Support, It seems to be problem with panel and before concluding make sure that ...
...power to the panel as well as the klystron tube. This is generally a slow blow 15 amp Buss fuse. Since these fuses deteriorate over time and they are sized to just hold the requested amps (15) to ...
panel. Input power to microwave checked and is good. Your stove should be on its own breaker or have its own fuse. Some models of stoves have fuses within their own control panels too. Check your home
...Panel "OFF" or ignitor is broken? The power went out while my wife was baking. When the power came back on the oven stopped working. She reset the control panel only to get "OFF" on the LED. Is there ...
Question about JES1384SF Microwave Oven
...operating. 23. Plug in microwave oven or reconnect power. William E. Miller, AS-EET http://www.MicrowaveControl.com Microwave Oven Control Panel Repair Nationwide "Recycling by repairing since
Question about JES1384SF Microwave Oven
...the power cuts out. The panel is shorting to metal parts. Was there any insulating materials you didn't put back on? You might try some black electrical tape applied to the edge of the control
Question about JES1384SF Microwave Oven
panel. How do I ensure the power rating matches the position on the rotary knob? I replaced the power and timing knob control panel. How do I ensure the power rating matches the position on the rotary
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions