Questions & Answers for: power crt mike

Ad

Question about CZ36V51 36" TV

1 Answer

...power led. i think the problem might be an ic chip (str z4214) but im not sure as im only a shade tree electronics guy. any suggestions would be greatly appreciated. thanks mike. check your horonital ...

Ad

Question about 20PT5441 TV

1 Answer

...my philips model # 20pt3732 not starting up no horizontal drive coming from tda 8841. Mike, First check out the voltages in the power supply start up circuits. You will need a schematic. good

Ad

Question about F36650 36" TV

1 Answer

power supply part- to make a CRT tv like your RCA36 incher- which is a beautiful machine- I have the RCA/PROSCAN 36 incher-LAST longer...You should always wait 5 min between turning it off and on. Don

Question about WS-65819 TV

1 Answer

mitsubishi power problem turn on power, light comes on for aprox. 2 sec. then off. did self test and got 2blink pause 2 blink please help if you can thx, mike turn off sleep mole

Question about KP-53HS10 TV

1 Answer

...thinking it is possibly the power supply, did you attempt to replace yours? Thanks Mike Ok I solved my own problem and posted the results here, http://www.fixya.com/support/t1692655-sony_kp_53hs10 ...

...chassis TAC9307, no start, but relay 'clicks'. No obvious electrolytic capacitor failure but power supply C801 (470 mfd, 200 V) replaced, no change. Relay picking usually means the low voltage ...

Question about FD Trinitron WEGA KV-32FS120 32" TV

2 Answers

...power outage. Now clickes when turned on and light flashes 5 then 3 times. and does not come on any ideas thanks mike flashes means cannot detects video signal. please apply fresh solder to CRT board ...

Question about 22" FLAT SCREEN CRT BLACK Monitor

1 Answer

monitor flashes on then off power light stays on whats wrong?? shows screen for about 3 seconds then goes black Some 22" Viewsonics will have worn out bulging capacitors in the power supply that ...

lo conecto a las entradas vid 1, vid 2, F front y ninguno funciona. It mike have got hit by a small power surge and if you unplug the set from the wall for 40 Min., then it should reset back to normal

Question about DU1901 TV

1 Answer

...the TV should have turned off and if not after trying the two 3 digit codes I will send you a link for a Power Scan; http://www.dishnetwork.com/SupportSection/power-scan-instructions - Mike

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76280 Answers

Cindy Wells

Level 3 Expert

6080 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Are you a Televison & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...