...be covered with rubber stopper or simply caked with mud. Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind
...be a 4 second pause between each code AND the codes will repeat. If you get codes, record them and post them and I'll see what I can suggest. Otherwise, check your spark plugs and wires - replace ...
WHILST DRIVIN MY MX5 SLOWLY LOST POWER !! PLEASE HELP ME !! MATT. I USED JUMP LEADS TO START MY MX5 , IT STARTED FINE BUT WHEN I WAS DRIVING IT SLOWLY BEGAN TO LOSE POWER THE LIGHTS DIMPED AND WENT I ...
92 Miata transmission shift boot replacement The shifter on the Miata appears to separate into two separate pieces. Once the shifter and knob is removed, you can see a small hole going down the length
Need help Jump statring The pos/neg are not labled which one is which!!! Red is positive. Black is negative. Negative goes to ground (car body and engine block). Positive goes to the starter. The ...
how to fit a soft top on mazda mx5 k reg i just bought a new vinyl soft top for my mazda mx5 but when i took it to a garage to be fitted they quoted me £100 just to put it on, i refuse to pay that ...
Mx 5 Eunos 1996 starting problems I have just posted a new problem but stated that I had replaced the solenoid. I did of course mean the coil pack. After replacing the solenoid check the tips of the ...
you pinched off the wires on the crank sensor, also does it have a coil pack? If it does leave me a post
2003 trouble code P0012 Miata Mustgo has a reasonable fix for this problem posted here(it was a 2001 Miata instead of a 2003). Code means timing is retarded. Bad cam sensor seems correct. My ...
Question about 1999 MX-5 Miata
How do I re-route the vacuum hoses to top manifold on 1999 Madza Miata My stupid CEL (Check Engine Light) came on and there are literally hundreds of postings on the internet with the same problem for
Usually answered in minutes!
124 Questions
134 Questions
103 Questions
83 Questions
73 Questions