Questions & Answers for: Volkswagen Passat s position

...& get the throttle body re-calibrated. Seems to be dealer only. Also, the t.p.s. (throttle position sensor) could be bad.

where and what is the throttle position sensor on where and what is the throttle position sensor on 1999 vw passat v6 see the air cleaner.follow the air duct leading to the intake manifold,there is a ...

I have a P0010 trouble code that shows Actuator A? Camshaft position{cmp} actuator P0010 - Camshaft Position Actuator A - Bank 1 Circuit Malfunction http://forums.vwvortex.com/zerothread?id=3864951

ok 1994 vw passat... battery wont hold its charge.. new battery new alternator.. battery cables look old and worn.. when I turn the key sometimes there is nothing just the fourways trun on.. I then ...

where is the crankshaft positioning sensor If you have a 2.8L V-6, it is at the lower end of the cam spindle (actually in the motor). The CAMshaft position sensor is at the top of the spindle (you can

p1613 on my 1999 GLS passat. P1613 = Malfunction indicator lamp [ MIL/CEL ] - open circuit / short to positive, fault is Wiring open circuit/short to positive which basically means the wiring to the ...

...Relay Circuit Short To Ground P1502Fuel Pump Relay Circuit Short To Positive P1505Closed Throttle Position Does Not Close/Open Circuit P1506Closed Throttle Position Switch Does Not Open./Short To ...

wipers get stuck in the upright position when they are turned off. When the windshield wipers are turned off, they go to the upright position as opposed to the down position. The wire part contacts ...

wipers sticking in upright position on 1999 vw passat when shut off they stop half way up windshield,staying in that position! Any suggestions! It sounds like they are in the "service position" If ...

new starter and battery but car will not start try this procedure switch ignition on position for 30 seconds then turn off ignition switch. then try see if engine starts. what engine? Automatic or ...