Question about Powerdrive PD422D 1/2 HP Security Plus Screw Drive Garage Door Opener
the door down into the pavement as opposed to trying to open it) and then goes back to its original position.. I have tried resetting the system, tinkering with the up and down dials but nothing works
Question about Powerdrive PD422D 1/2 HP Security Plus Screw Drive Garage Door Opener
...opener. It was working fine until the emergency release was pulled while the door was in the open position. Now the door will open without a problem but the door seperates from the drive track when ...
Question about Powerdrive PD422D 1/2 HP Security Plus Screw Drive Garage Door Opener
...on its own. adjust down travel. or, you may have chain out of sync and will need to reset chain in position. get motor up and put chain on in up ...
Question about Powerdrive PD422D 1/2 HP Security Plus Screw Drive Garage Door Opener
Electric lock on overhead garage door does not engage when locked. These new openers have a positive lock position. When the door is down it is locked unless the door reverses. Thanks
...Set-Up. 1. Press and Hold Red Stop Button, and while holding, press the SET button 3 times. 2. Position door into desired CLOSED position. 3. Press the SET button to save this as the CLOSED ...
Question about 3/4-HP Whisper Drive Plus Evercharge Standby Garage Access System
...it stops at botton, it turns and goes back up ??? Need adjusting ..How can I adjust??? Adjust the position of the door by using the black and purple buttons. Black moves the door UP (open) and ...
Question about Sears Craftsman 950cb 953c
...close all the way. It started going down and reverse back up your chain is in the wrong position, unhook the chain and run the door opener so it is in the down position, then reattach the ...
Question about 3/4-HP Power Drive Chain Drive Garage Access System
...the door is going up, it will go up Check your manual and re-program the up/stop and down/stop position. Also make sure the new trolly is in it's proper position.(in the closed
Question about 1/2-HP Whisper Drive Belt Drive Garage Access System
...release rope is connected to is pointing towards the motor unit, and raise/lower the door to the position of the inner carriage, so that they will engage. If the inner carriage is fully closed and ...
Question about Clicker Universal Garage Door Opener Remote Control, Replacement
Why does the klik2 unit stop working when mounted to wa ll? It should work in any position. Is there metal in the wall that could shield the remote from the receiver? Try the remote in different ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions