my polk audio speakers volume wont go up polk audio speakers volume wont go up why i have 2.1 creative sound speaker .after system formattednosound observed.pse solve the problem.
Polk Audio PSW 350 sub has no power Trying to replace fuse type T1.25A 250V but can't find retailer that knows what types of fuse a T1.25A is....Fast, time delay, etc, Hi, Just call the parts line at ...
Question about PSW404 Subwoofer
my polk psw404 has no power, I check the fuse at power source my polk psw404 has no power, I check the fuse at the power chord...replaced it ( the original seemed to be fine) but still nothing What ...
polk rti6 tweers blown...4 speakers.....can these tweeters be repaired It may be possible to have the tweeters repaired by Polk however if you have the skills your least expensive route would be to ...
Polk Audio RTi4 voice coil burned out Order a Re-Cone kit from Polk, or have a local company re-cone it. It can be a little tricky if you haven't done a recone before.
subwoofer set up polk audio 6750 how do i set up the subwoofer for a polk audio 6750 Connect the subwoofer to an amplifier/audio receiver with the proper cables. Reply back with your setup so I can ...
Question about RTi4 Main / Stereo Speaker
my polk subwoofer makes a heartbeat sound and is not working, I have reset it before I just don't remember how to do it. Help!! Power off the sub. Push the reset then power back on. Fixed PSW125 ...
Question about PSW Series PSW10 Black 10-inch Powered Subwoofer Each
Where is the fuse in Polk psw 10 subwoofer? You will have to remove the plate amp and look on the pcb, it is generally located near where the main power lines come in. If you still can' find it ...
Question about PSW Series PSW10 Black 10-inch Powered Subwoofer Each
What type a fuse do I use for my Psw 125 power sub Is this a Polk PSW 125? I'd contact Polk customer service. Here is the manual http://www.polkaudio.com/Media/POLK/Product%20Manuals/PSW110_125_MN.pdf
Question about PSW Series PSW10 Black 10-inch Powered Subwoofer Each
Polk audio pa660 is in protection mode how do I reset it. Lots of help in the links Amp goes into protection mode - Polk Audio Forum https://forum.polkaudio.com > discussion > amp-goes-i... Nov 26, ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions