My Nordic Track Exp 1000 X runs in reverse. our repairman was working and needed to move our treadmill. When he moved it back he stated it no longer worked. I was able to get it running after I pushed
Question about NordicTrack Treadmill, A2550
instructions to reset a nordictrack cardio track watch You may have started wearing a Polar F11 Fitness heart rate monitor to help you keep track of your pulse during cardiovascular exercise. The ...
how do you reset cardio track watch u may have started wearing a Polar F11 Fitness heart rate monitor to help you keep track of your pulse during cardiovascular exercise. The monitor consists of a ...
panel lights dim blue panel illumination (blue) dimming, so can't read speed, incline, time numbers. Machine over five years old. Can this be fixed. 1) Replace the batteries by new ones, same ...
Question about Nodictrack A2250 Console Treadmill
When I plug my Nordictrack A2250 in the fan runs and the screen is blue, none of the buttons work. This is without the safety pin attached. Adjust the REED switch, test it, clean it, and tight the ...
Question about Nordictrack A2350 Treadmill Console Etsn79917
fuse looks ok red light lit even without fuse no power to consol no power to consol, reed switch ok fuse ok red light lit 1)Replace the batteries with full charges, with the same mark, do not mix ...
CONSOLE BEEPING Adjust the REED swithc, test for open or faulty, see the diagram. Clean it , and tight the connector very well 2) Replace the batteries by new ones, with the same types such hybrids ...
Question about Treadmill Motor Controller Mc5100dts-50w 37376 Pn 285703 -
NORDICTRACK X9I CALORIE COUNTER IS WRONG Repairmen said Controller is nothing to do with the calorie counter but yet Console and Rear roller was replaced so what else could it be or is it the ...
Question about Treadmill Motor Controller Mc5100dts-50w 37376 Pn 285703 -
F63 SOLE TREADMILL SCREEN LED FADING The led lights on my sole treadmill screen are fading. You can see most of the stats, but some are hard to read due to lights being out. Thanks, Dayna 1) replace ...
Incline is reversed Hey Carlos Did you remove any wire on the incline motor anytime? if so then see that the + and - leads were connected to the correct pins. If not then switch them as this would ...
Usually answered in minutes!
346 Questions
56 Questions
48 Questions
44 Questions