Questions & Answers for: Lexmark platen

IBM Wheelwriter 10 Series II I cleaned off labels and gunk on the platen. Now only the upper parts of letters appear when typing. Tried a new ribbon and that didn't work. I assume you had the platen ...

The platen does not turn to advance the paper to the next line when typing so each line is just typing over the next. Remove the platen by squeexing the black plastic retainers at both ends of the ...

Need to remove the Platen to remove paper. I noticed that there are labels stuck under the platen on the silver paper level. I have not been able to remove the platen. Any suggestions????? We have the

...dropped and now the paper cylinder does not rotate, what could it be? Check to be sure the platen is still fully seated in the side frames. Align the blacl latches with the side frames and ...

...I type it is only printing 1/2 of the letters and or numbers it is cutting off the bottom half The platen (black roller) probably isn't fully seated, press down firmly on both ends of the platen. If ...

letters incomplete needs platen I assume that the platen is split otherwise it ma not be fully seated in the side frames. Press firmly on both side it will snap into place. If you need a platen we ...

Have a Nakajima WPT-150 typewriter that has label stuck to the platen. How to fix? I haven't worked on a 150 for a while but I believe that the left platen bearing rotates to a position where the ...

how to remove platen On both ends of the platen there is black plastic latch squeeze them and lift out the platen. DickyO

remove platen on IBM Wheelwriter 1000 by Lexmark There are 2 black plastic latches one at each end of the platen squeeze them together and lift out platen. DizkyO

wheelwriter platen latch removal Very vague question. the left side you have to drive the pin out. right side just a clip. If the platen wont stay down you can carefully wire it down so it doesnt ...