Question about CanoScan LiDE 500F Flatbed Scanner
...lid near one of the hinges. Flip it back and forth and leave it in the unlocked position. If this doesn't work, then it will most likely need service. Contact Canon Tech Support. I had the exact same ...
...lid hinges slot into gently pry the black plastic part away from the grey plastic body, starting near the glass until it tilts up and away. be careful of the clips at the back end of the scanner the ...
...lid hinges slot into gently pry the black plastic part away from the grey plastic body, starting near the glass until it tilts up and away. be careful of the clips at the back end of the scanner the ...
Question about CanoScan LiDE 25 Flatbed Scanner
...lid and locate the two oval plastic patches at the left and right front corners. These cannot be peeled off because they are part of the frame that secures the glass plate. You need to lift each oval ...
lid when it is set to scan an opaque object like an 8x10). I ordered a replacement part from the Canon parts center in New Jersey (732-521-7230) and at the time she told me there were only two left in
Question about CanoScan 9950F Flatbed Scanner
...lid hinges were inserted. Starting near the hinge slots, pry the black plastic frame up and away from the gray plastic body. Slide the glass panel and its gray plastic frame towards the back of the ...
Question about CanoScan 8600F Flatbed Scanner
...plastic backing on the inside of the lid that needed to be removed. Also remove all protective plastic too. hi. use the usb cable to hook your scanner up to your computer and then use your scanner ...
Question about CanoScan 3000F Flatbed Scanner
...plastic slide support which came with the 3000F CanoScan. However Code2,181,0 keeps popping up even though the support is aligned correctly by arrows. The problem is resolved. I continued searching ...
Question about CanoScan 8000F Flatbed Scanner
...plastic ivory looking handles they have a round edge at the end that type C - Patience To clean the platen on the Canon 8000f 1. Take the lid off 2. At the bottom of the post holes remove the 2 small ...
Usually answered in minutes!
391 Questions
150 Questions
139 Questions
130 Questions
108 Questions