Question about Premium CTP 3153 Top Freezer Refrigerator
...out of plastic to put there. Then undo the top hinge, and carefully lift the door off (you might want to empty the shelfs). Put your spacer on the hinge pin, and replace the door and the top
...plastic hinge is held in place by four plastic rods. When pushed through the body of the car, they expand four rubber sleeves located on the interior, thereby holding the whole thing in place. ...
hinge pin area. Also, the small round plastic bushings, flat on one end, which fit around the hinge pins are worn and broken. I had this problem. I reversed the decorative plastic strips, both ends of
...plastic plugs and install the hinge supports and doors in reverse order (bottom to top) on the other side. If there are separate door stops on the bottoms of the doors near the hinges that keep the ...
Question about Classixx KSR32623 Refrigerator
...hinge of the door. Pry the (plastic) cover off if there is one. Remove the bolts/screws and remove the hinge support. There is a post on it that fits into the hole at the top of the door. Remove the ...
Question about Classixx KSR32623 Refrigerator
...plastic grommets.
Remove the lower hinge remove the upper hinge.Install lower hinge just as it came off and then do the upper hinge. tighten down the hinges then see if the door needs ...
Question about RM2652 Refrigerator
plastic hinge on the door the hinge is not plastic, only the insert sleeve that goes into the hole atop the door is plastic. If the actual hinge (metal arm) is broke, then you need to order a new part
...hinge look for plastic washers on top and bottom remember where they go you can add a couple metal washers on the bottom hinge then put the plastic one back on this will raise the door slightly. You ...
...plastic plugs so ya can move the hinge over. Remove the top hinge and the top door lifts off. Move the handle to the other side. Next remove the middle hinge and lift the bottom door off the base ...
...hinge edge -use plastic spoon handles to encourage caps to pop off. May also require small screwdriver approx 1/8" in to complete pop off 9. remove the 2 phillips screws w/ captive washers 10. remove ...
Usually answered in minutes!
3,171 Questions
1,894 Questions
1,239 Questions
1,098 Questions
927 Questions